Kobe CHX3830SQB-WM-2 Handbuch PDF herunterladen (Seite 14)

11

Wiring to Power Supply

CAUTION

: If moving the cooking range is

necessary to install the hood, turn off the power

in an electric range at the main electrical box.

SHUT OFF THE GAS BEFORE MOVING A GAS

RANGE. RISK OF ELECTRICAL SHOCK.

THIS RANGE HOOD MUST BE PROPERLY

GROUNDED. MAKE SURE THIS IS DONE BY

QUALIFIED ELECTRICIAN IN ACCORDANCE

WITH ALL APPLICABLE NATIONAL AND LOCAL

ELECTRICAL CODES. BEFORE CONNECTING

WIRES, SWITCH POWER OFF AT SERVICE

PANEL AND LOCK SERVICE PANEL TO

PREVENT POWER FROM BEING SWITCHED ON

ACCIDENTALLY.

8. If hood is operating normally, connect three

wires (black, white and green) to house wires

and cap with wire connectors.

9. Store wires in the wiring box.

Ductwork Installation

10. Use steel pipe to connect the exhaust on the

hood to the ductwork. Use duct tape to make all

joints secure and air tight.

Duct Cover Installation

11. Mark the position of the Duct Cover-Mounting

Bracket {O}. Use reference E from Table 2 and

measurements on page 16-17. Attach and

secure Duct Cover-Mounting Bracket {O} with

two screws (provided). (Figure 16) NOTE: Inner

duct cover will cover the duct cover-mounting

bracket.

12. Position the entire duct cover up onto the hood.

13. Secure the inner duct cover with two (3/16” x

3/8”) screws {L} to the duct cover-mounting

bracket. Shown in Figure 17.

14. Fasten outer duct cover to Duct Cover Support

{N} with four (4 x 6 mm) screws {L}

Figure 16

Figure 17

Attach Together

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare